Table of Contents
Advertisement
2.
Select (click) a reset level (see
NOTES:
•
Reset Device Settings (Retains TCP/IP Settings and Password) —
Resets configuration settings. All communication settings and the password
are retained. See the
page 41.
•
Reset All Settings and Delete Files (Retains TCP/IP Settings) —
Resets configuration settings except the communication settings, which are
maintained. Resets the password to the default, which is extron. See the
table
of communication and configuration settings.
•
Reset All Settings and Delete Files — This reset is identical to the Mode 5
reset (see the
table
3.
Click APPLY (
4
).
The decoder reports that it is Resetting and Rebooting
and displays a status bar that shows the progress of the
operation. Any of these operations concludes with the
decoder rebooting.
NOTE: You must reconnect to the decoder (see
Opening the Embedded HTML Pages
if you have additional operations to perform.
NAV 10SD 501 and NAV 10SD 101 Scaling Decoders • HTML Operation
figure
38,
2
on page 43) or Reboot (
table
of communication and configuration settings on
of rear panel reset modes on page 16).
on page 18)
3
).
44
Advertisement
Table of Contents
Need help?
Do you have a question about the NAV 10SD 101 and is the answer not in the manual?
Questions and answers