Diagnostic Tools Page - Extron electronics NAV 10SD 101 User Manual

Diagnostic Tools page

The Diagnostic Tools page (see figure 39) provides tools that allow you to troubleshoot
the connection to other units on the NAV network. Access the page as follows:
1. Click the TOOLS > Diagnostic Tools link on the left side of the browser (
browser displays the Diagnostic Tools page.
2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2
3 3 3 3 3 3 3 3 3 3 3 3 3 3 3 3 3 3
4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4 4
1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1
5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5 5
Figure 39.
2. Click in the Address field and type in the IP address of another unit on the network (
3. Click either PING or TRACE (
4. Click CLEAR (
Diagnostic Tools Page, Ping Results Shown
3
NOTES:
• Ping — Use this tool to test the connection to another unit on the network.
Figure 39, 4 shows the typical results of a Ping diagnostic. If you see the
Ping to Host Address has Timed
message:
administrator to troubleshoot.
• Trace — Traces the network route taken by a packet from source to
destination and displays the network packet path as it traverses the network. If
a trace is not fully successful, the diagnostic displays where the packet was last
successful before it stopped and can no longer communicate to the next hop.
Figure 40 shows the typical results of a Trace diagnostic.
Figure 40. Trace Results Shown
) to reset the Address field if you want to run another diagnostic.
5
NAV 10SD 501 and NAV 10SD 101 Scaling Decoders • HTML Operation
), depending on the diagnostic you want to run.
Out...,
1 ). The
2
).
contact your system
45