Extron electronics NAV 10SD 501 Setup Manual

NAV 10SD 501 and NAV 10SD 101 • Setup Guide
CLASS 1 LASER PRODUCT, see
WARNING:
The NAV 10SD 501 and NAV 10SD 101 output continuous invisible light (Class 1 rated), which may be harmful to the
eyes; use with caution.
• Do not look into the fiber optic cable connectors or into the fiber optic cables themselves.
• Plug the attached dust caps into the optical transceivers when the fiber cable is unplugged.
AVERTISSEMENT :
peut être dangereuse pour les yeux ; à utiliser avec précaution.
• Ne pas fixer directement les connecteurs optiques ou les câbles fibre optique.
• Associez les bouchons anti-poussière à l'ensemble émetteur/récepteur optique lorsque le câble fibre optique est débranché.
This guide provides instructions for an experienced installer to install the Extron NAV 10SD 501 and NAV 10SD 101 scaling decoders and
to make all connections. One or more compatible Extron NAV encoders and one or more decoders form an AV distribution and switching
matrix on a managed 10G IP network.
NOTE
For more information on any subject in this guide, see the NAV 10SD 501 and NAV 10SD 101 User Guide, available at
:
.
www.extron.com
Installation
Step 1 — Mounting
Turn off or disconnect all equipment power sources and mount the decoder as required.
Step 2 — Rear Panel Connections
POWER
12V
2.0 A MAX
H H H
POWER
12V
2.0 A MAX
NAV 10SD 501 and NAV 10SD 101 Rear Panel Features
Figure 1.
A NAV 10G port — Use a pair of fiber cables to connect to an Ethernet LAN on which one or more encoders also reside for streaming
and control.
NOTE: Ensure that you use the proper fiber cable for your encoder. Typically, singlemode fiber has a yellow jacket
and multimode cable has an orange or aqua jacket.
B Extension port (NAV 10SD 501 only) — If desired, connect another networked device to this port. The port acts as a networked 1G
switch to the NAV 10G port.
C HDMI output port — Connect an HDMI cable between this port and an HDMI display (or a DVI display, with an appropriate adapter).
See LockIt Lacing Brackets
®
D
Audio output port — This 5-pole, 3.5 mm captive screw connector outputs the streamed, unamplified, line level analog audio. Connect
an audio device, such as an audio amplifier or powered speakers (see
connector).
NAV 10SD 501 and NAV 10SD 101
Le NAV 10SD 501 et le NAV 10SD 101 émettent une lumière invisible en continu (équipement de classe 1) qui
OUTPUT
AUDIO
L R
HDMI
C C C D D D
OUTPUT
AUDIO
L R
HDMI
on page 6 to use the LockIt HDMI Cable Lacing Bracket to secure the connector to the decoder.
User Guide at
CONTROL
USB 2.0
RS-232 IR
Tx Rx G S G
5V/200 mA
E E E F F F
CONTROL
RS-232 IR
Tx Rx G S G
Analog audio output connector
www.extron.com
NAV 10SD 501
LAN
RESET
NAV 10G EXT
A A A B B B G G G
NAV 10SD 101
LAN
RESET
NAV 10G
on page 6 to wire the
1