Nortel ICS 7.1 Coordinator Manual page 76

76 / Making calls
Modular ICS 7.1 System Coordinator Guide
Your telephone is already connected to the
telephone you are trying to call. Check your
active line buttons, and return to that call.
Wait for the telephone to be answered. If no
one answers, press
Again (page 84) or Message (page 127)
feature, or press
call.
You cannot use Ring Again on your current
call. You can only use Ring Again while you
have a busy signal on an internal call or line
pool request or while an internal call is
ringing.
The telephone you are calling has Do Not
Disturb turned on. Press
Ring Again or Messages features, or press
to make a priority call.
You have dialed a number, but the least
expensive route that the system is
programmed to use is busy. Unless you
release the call, it goes through on a more
expensive route.
The last number you dialed or the number
you saved for Saved Number Redial was a
speed dial number that displayed a name
rather than the number. The number is dialed
correctly, but you cannot see it.
You have attempted to use the private line
assigned to another user.
Enter the digits of the number you want to
dial.
You have not dialed an external telephone
number since the last power interruption or
system reset.
Either you have no prime line or your prime
line is busy. Select a line manually before
dialing.
You have entered the number of a telephone
that is not in service.
to use the Ring
to make a priority
to use the
N0130946 01