Changing User Speed Dial - Nortel ICS 7.1 Coordinator Manual

Note: User Preferences programming cannot change the
buttons that are used by lines, intercom, and the handsfree
feature, which are assigned by the system administrator. Refer
to the Modular ICS 7.1 Installer Guide for details.

Changing User Speed Dial

1. Press
the number of speed dial codes that are available.
2. Press
3. Press
4. Press
5. Press
way you would dial it on the telephone.
6. Press
7. Press
line pool) the speed dial code should use.
Use the line pool code to select a particular line pool for use
with Speed Dial. If you select
is chosen by the routing programming according to the initial
digits in the number.
The route you choose for a User Speed Dial code must be one
that the telephone can use. For example, if the telephone does
not have access to Line Pool B and you use that pool code with
the speed dial code, the code does not work. Lines and line
pools are assigned to the telephones by the system
N0130946 01
Locates a specific button on a telephone by entering its
number. Button numbers are shown in the illustrations.
Takes you to a list of feature codes. Press
move through the list and press
feature you want to program on the button.
at
to see the first speed dial code (256).
to move through all the speed dial codes.
to find the code you want to change.
and enter the telephone number the same
.
and choose the line (or enter a code for a
Using User Preferences / 161
when you see the
. The display shows
, a line or pool
Modular ICS 7.1 System Coordinator Guide
to