Table of Contents
Advertisement
7. Choose a setting at
There are three ways to set handsfree for a telephone:
For other displays, see Common feature displays on page 249.
Both Auto and Standard handsfree allow you to use a headset
with a system digital phone.
A handsfree/mute button is automatically assigned to a legacy
Norstar telephone that is programmed with handsfree and is
always located in the lower right-hand corner of the memory
button rows. For 7208 and 7316 digital phones, this button is
assigned as a handsfree-only button. The mute button is
located under the dial pad.
The handsfree setting for 7316E digital phones only displays
or
located under the dialpad. If
handsfree button and headset feature do not function. Also, if
the 7316E is attached to a system with software previous to
MICS version 6.1, it acts like the 7316 digital phone, and the
handsfree button under the dial pad is not active.
N0130946 01
Handsfree is not available to the telephone.
A standard version of handsfree described
Using handsfree and mute on page 66. Not
available for 7316E digital phones.
This prompt appears if you attempt to use
handsfree or headset and the telephone not
been configured with
You can make or answer a call without
having to pick up the receiver or press the
button marked handsfree/mute. The internal
microphone of the telephone and the
speaker turn on automatically when you
press a line or intercom button to make or
answer a call.
. The handsfree button on this telephone is
Using handsfree and mute / 71
using the
under
is set to
Modular ICS 7.1 System Coordinator Guide
button.
.
, the
Advertisement
Table of Contents
