Table of Contents
Advertisement
2. Installation
2.
Remove the SD card slot cover [A] (
3.
Make sure that a target SD card is in SD Card Slot 1 (upper). The application program is
moved to this SD card.
4.
Insert the source SD card with the application program in SD Card Slot 2 (lower). The
application program is copied from this source SD card.
5.
Turn ON the main power.
6.
Enter the SP mode.
7.
Select SP5-873-001 "Move Exec".
8.
Follow the messages shown on the operation panel.
9.
Turn OFF the main power.
10.
Remove the source SD card from SD Card Slot 2 (right).
11.
Attach the slot cover.
12.
Turn ON the main power.
13.
Check that the application programs run properly.
Undo Exec
"Undo Exec" (SP5-873-002) lets you move back application programs from an SD card in SD Card
Slot 1 (upper) to the original SD card in SD Card Slot 2 (lower). You can use this program when, for
example, you have mistakenly copied some programs by using Move Exec (SP5-873-001).
150
x2).
Advertisement
Table of Contents
Troubleshooting
