Connecting To The Gigabit Ethernet Interface - Ricoh MP CW2201 Field Service Manual

10. Make sure that the size of paper roll you loaded is displayed correctly on the screen.
• When [Film (Matte)] is specified for Paper Type or when Prevent Paper Abrasion is specified, touch
[Exit] on the screen after lowering the paper input location cover. You can change the Prevent
Paper Abrasion setting in System Settings if necessary. However, if you specify [Film (Matte)] for
Paper Type, the Prevent Paper Abrasion setting is automatically selected, and you cannot change
it. For details about Prevent Paper Abrasion, refer to the user guide.
• When the settings in step 9 are finished, the machine pulls the paper inside, and paper is output
about one meter (40 inches) from the paper output location. Then the machine rewinds the paper
to the prescribed position. Do not touch the output paper until the machine stops moving. If you
select [Cut] in step 8, the edge of the paper is cut off.
• If you insert a roll of paper into the machine at an angle or if there is space between the paper and
the flanges, the paper may not be pulled into the inside of the machine. If that happens, return to
step 1 and start again.
• When you load two paper rolls into Paper Input Locations 1 and 2 in succession, make sure that
the paper size you loaded first is displayed on the screen correctly, and then load the other paper
roll into the other paper input location.
• When the [Notification Sound] is set to [No Sound], it will not sound if you insert paper into the
paper input location. For details about [Notification Sound], refer to the user guide.
• You can specify the types of paper you load in the paper input location in advance. For details,
refer to the user guide.
• For details about the settings for the paper thickness and types, refer to the user guide.
• For details about how to store the paper roll, refer to the user guide.

Connecting to the Gigabit Ethernet Interface

This section describes how to connect an Ethernet interface cable to the Gigabit Ethernet port.
If you use an Ethernet interface cable that supports 1000BASE-T, set [Ethernet Speed] to [Auto Select:
Enable 1Gbps] in [Interface Settings] in [System Settings].
• Properly shielded and grounded cables and connectors must be used for connections to a host
computer (and/or peripheral) in order to meet emission limits.
• If the main power switch is on, turn it off.
• Use the following Ethernet cables.
• When using 100BASE-TX/10BASE-T:
Main Machine Installation
135