YASKAWA CIMR-DC4A0040AAA Technical Manual page 57

Models 2A0030 to 2A0130, and 4A0030 to 4A0370
1.
Remove the terminal cover and the digital operator.
2.
Loosen the installation screw on the front cover.
3.
Use a straight-edge screwdriver to loosen the hooks on each side of the cover that hold it in place.
Figure 3.18
Front cover
installation screw
Figure 3.18 Remove the Front Cover (2A0030 to 2A0130, and 4A0030 to 4A0370)
4.
Unhook the left side of the front cover then swing the left side towards you as shown in
cover comes off.
Figure 3.19
Figure 3.19 Remove the Front Cover (2A0030 to 2A0130, and 4A0030 to 4A0370)
Reattaching the Front Cover
■
Models 2A0005 to 2A0020 and 4A0005 to 4A0020
Reverse the instructions given in
page 54 to reattach the front cover. Pinch inwards on the hooks found on each side of the front cover while guiding it
back into the converter. Make sure it clicks firmly into place.
Models 2A0030 to 2A0130 and 4A0030 to 4A0370
1.
Slide the front cover so the hooks on the top connect to the converter.
Figure 3.20
Figure 3.20 Reattach the Front Cover (2A0030 to 2A0130, and 4A0030 to 4A0370)
2.
After connecting the hooks to the converter, press firmly on the cover to lock it into place.
YASKAWA ELECTRIC SIEP C710656 06F YASKAWA Power Regenerative Converter - D1000 Technical Manual
Hook
Models 2A0005 to 2A0020, 4A0005 to 4A0020 (IP20/Open Type Enclosure) on
3.6 Digital Operator and Front Cover
Hook
Free hooks on both
sides of the cover
Figure 3.16 until the
57
3