Connecting Standard Configuration Devices And Peripheral; Devices - YASKAWA CIMR-DC4A0040AAA Technical Manual

7.3 Connecting Standard Configuration Devices and Peripheral Devices
Figure 7.1 illustrates how to configure the converter with standard configuration devices, peripheral devices, and
options.
Note: Refer to Standard Connection Diagram on page 46
Figure 7.1
Power
Supply
Line Breaker
(MCCB)
or
Surge
Leakage
Absorber
Breaker
Magnetic
Contactor
(MC)
Zero-phase
Reactor
Standard Configuration
24V Power

Devices

<1>
Supply
Harmonic
Filter
Module
Input-side
AC Reactor
<1> A corresponding input-side AC reactor and harmonic filter module that consider the saturation current and thermal factors are required for each
model of converter. Always install the specified devices.
Figure 7.1 Connecting Standard Configuration Devices and Peripheral Devices
Note: 1. If the converter is set to trigger a fault output when the fault restart function is activated (L5-02 = 1), then a sequence to interrupt
power when a fault occurs will turn off the power to the converter while the converter attempts to restart. The default setting for
L5-02 is 0 (fault output active during restart).
2. When connecting a converter to the GA700, use an EMC noise filter designed for the D1000. Do not use models of the GA700
models with built-in EMC noise filters.
YASKAWA ELECTRIC SIEP C710656 06F YASKAWA Power Regenerative Converter - D1000 Technical Manual
7.3 Connecting Standard Configuration Devices and Peripheral Devices
for details on connecting standard configuration devices.
Converter
Ground
r1/ 11 1/ 21 t1/ 31 R/L1 S/L2 T/L3 - +
(Model 2A0030, 2A0130, 4A0030 to 4A0185)
Engineering
Software Tools
DriveWizardPlus
LED Operator/LCD Operator
USB Cable
USB
(Type-AB)
Copy Unit
PC
USB Cable
(Type-AB, sold separately)
Drive
Ground
+ 1 - U/T1 V/T2 W/T3
Motor
Ground
155
7