YASKAWA CIMR-DC4A0040AAA Technical Manual page 39

■ Installation Spacing
Figure 2.11 shows the installation distance required to maintain sufficient space for airflow and wiring.
Figure 2.10
■ Precautions and Instructions for Installation of Harmonic Filter Module
Read the following precautions and instructions before installing a harmonic filter module.
WARNING! Always observe the following precautions. If handled incorrectly, the harmonic filter module may fall, possibly causing
injury. Also, the harmonic filter module may be damaged.
• Suspend the harmonic filter module with wires only temporarily and only when installing them in a
control panel. Do not suspend them when transporting them.
• Before you suspend the harmonic filter module, confirm that faceplate, top cover, and other
configuration components are securely screwed in place.
• Do not place the harmonic filter module on its side.
• Do not leave the harmonic filter module suspended with wires for a long period of time.
CAUTION! Hold the specified locations when carrying a harmonic filter module by hand. Holding any other location when carrying the
harmonic filter module could cause the module could fall and cause injury.
NOTICE: Do not disconnect the wiring to the converter and harmonic filter module while the converter is outputting a voltage. Improper
equipment sequencing could result in damage to the converter.
Attach hooks to the specified locations when suspending the harmonic filter module with wires.
NOTICE: Do not apply excessive force to the top cover when suspending the harmonic filter.
The top cover may be deformed. When lifting the module by hand, always use the holding frames and use two people. Failure to
comply may damage the module.
Refer to Figure 2.12 and
Figure 2.11
A – Suspension Holes (Two on Each Side)
YASKAWA ELECTRIC SIEP C710656 06F YASKAWA Power Regenerative Converter - D1000 Technical Manual
A
C
B
A – 50 mm minimum
B – 30 mm minimum
Figure 2.11 Installation Spacing
Figure 2.13 for details.
B
Figure 2.12 Suspension Locations for the Harmonic Filter Module
2.3 Harmonic Filter Module Installation
B
C – 120 mm minimum
A
A
B
B – Holding Frames (One on Each Side)
B
A
A
2
39