Operation In "Standard Operator" Mode; Figure 74: Program Is Running In Standard Operator Mode With Restricted Rights - Fluke TIP900 Operating Instructions Manual

5.2.2 Operation in "Standard Operator" mode

Figure 74: Program is running in Standard Operator mode with restricted rights

A double click on the icon in Figure 36: Created TIP900 icons during SW installation process
starts the program in the standard operator mode with restricted rights. In such mode is just a
reduced main menu with five (5) selection items available.
In the standard operator mode some selector push buttons are grayed out and disabled for activation.
A logged in supervisor may assign some extra power to the standard operator and enables to activate
grayed out elements.
As a standard operator, without assigned extra power by the supervisor, you're not able to edit or
configure system relevant parameters.
If the program is started the very first time after SW installation, an empty supervisor password is preset
and needs to be updated by a valid one. The responsible supervisor has to take care about this and the
chosen password must be treated confidentially.
Please see chapters 5.2.1.1.2 until 5.2.1.1.8 for detailed information regarding the five (5) selection
items for the related functionalities and parameters.
TIP900
Standard Operator mode  reduced selection menu
Rev. E1 Feb 2016
Operation
75