Table of Contents
Advertisement
Operation
5.2.3 Operation in "Supervisor" mode
Supervisor mode extended selection menu
Figure 75: Program is running in Supervisor mode with administration rights
The standard operator mode can be left by clicking onto the selector button
and
enter the correct password in the subsequent window.
A valid supervisor password has to be preset on the very first start of the program after installation. The
supervisor has to take care about the chosen password and must treat it confidential. After entering the
correct supervisor password, the main menu selection bar is extended by two extra items
and
with additional rights to configure parameters.
The supervisor has all administrative rights and is able to assign specific power (rights) to the standard
operator. Please see chapters 5.2.1.1.2 until 5.2.1.1.8 for detailed information regarding the seven (7)
selection items for the related functionalities and parameters. Especially the edit and configuration power
distinguishes the supervisor from the standard operator. Such aspect has to be handled with care,
because it influences the production and process quality, if automatic side track (board set rejection) is
enabled.
As a safety feature is an automatic logout from supervisor mode integrated, which takes place after
about 5 minutes without supervisor interaction. This should avoid leaving all supervisor priorities to the
standard operator staff in case of missing a correct logout as supervisor.
76
TIP900
Rev. E1 Feb 2016
Advertisement
Table of Contents
