The Boards Display; Figure 63: The Boards Display Shows A Currently Scanned Set Of Wallboards - Fluke TIP900 Operating Instructions Manual

Operation
Temperature Color Table:
3
Temperature Color Slider:
4

5.2.1.3.2 The Boards display

Figure 63: The Boards Display shows a currently scanned set of wallboards

The boards display under process screens is similar to the boards map display, already described under
chapter 5.2.1.2. Herein the good or bad boards are individually marked in green or red color to identify
defects on single board level. Regarding the boards map display in chapter 5.2.1.2, there is just one
outer frame per boards set, to identify defects on boards set level. No differentiation to a single board is
possible there.
66
Temperature color table as temperature bar, to distinguish the
different board temperature values by color.
Temperature color slider, to shift the color  temperature
assignment manually by the left and right slider. The related
scope (Manually, Automatic) is settable globally under the
configuration item. See chapter 5.2.1.1.4 for details regarding
the "Scaling Type" parameter in section Dryer Profile Settings.
Rev. E1 Feb 2016
TIP900