Operation
5.2.1.1.2 The "Product Recipe" selector in the menu bar
The Product Recipe selector button allows the selection of a preconfigured recipe.
Just the Supervisor is able to edit and preconfigure different recipes, which are selectable in a production
process change by the operator.
In general the Product Recipe selector is for viewing and verification of recipe specific parameters for a
chosen gypsum wallboard production recipe.
Figure 40: Product Recipe selection screen in Operator or Supervisor mode
Name:
Reference map per deck:
The "General" and the "Defect Detection" parameters are shown in the red marked box
preset by the Supervisor during the recipe creation.
See all to box
assigned parameters in the following description:
3
42
1
2
3
The recipe name, established during recipe creation by the
Supervisor, has to be selected in the drop down list
The defined (good, error free) board maps, which have to be
assigned by the Supervisor per dryer deck as reference maps. A
click on the right small deck picture shows the reference board map
as a big picture in the upper left display area
Rev. E1 Feb 2016
2
1
2
and are
3
TIP900