Table of Contents
Advertisement
Dryer Chain Side:
Leading Edge:
Operator can set temp. range:
Auto Temp Scaling access for Operator: Allow the Operator to enable/disable the automatic
Enable auto temp. scaling:
Temperature unit:
Show leading and trailing edge:
Show the operator side:
Show the deck number:
Show the maximum temperature:
Show the temp. comp. value:
Show unknown decks in history:
TIP900
time Dropgate → Scanner" and the distance between them
should be at least 1 second. This parameter will be overridden
by the corresponding recipe parameter.
Displays the Dryer Chain Side on the board map image.
Selection criteria is "Left" or "Right"
Selection criteria are "Top" or "Bottom". When "Top" is
selected, the leading edge of the boards is on top of the board
map image.
-- Temperature Settings --
The operator is allowed to set the temperature range. If
disabled, only the supervisor can change the temperature
range. Possible selection is Yes/No.
temperature scaling feature. Possible selection is Yes/No.
Enables/Disables the automatic temperature scaling feature.
Possible selection is Yes/No.
The default temperature unit in the TIP900 application and in
the LogViewer. Changes require an application restart to take
effect.
-- Image View Settings --
Displays the position of the leading and trailing edge overlaid
in the board map image for correct orientation. Possible
selection is Yes/No.
Displays the side of the operator overlaid in the board map
image. Possible selection is Yes/No.
Displays the currently processed deck number as overlay in
the board map image and the separated board maps view.
Possible selection is Yes/No.
Displays the maximum temperature overlaid in the board map
image. Possible selection is Yes/No.
Displays the current temperature compensation value
overlaid in the board map image. Possible selection is
Yes/No.
-- History Settings --
Displays board maps with unknown decks origin in the history.
Possible selection is Yes/No. This is a very important field to
identify
wrong
parameters).
Rev. E1 Feb 2016
process
configurations
Operation
(e.
g.
timing
49
Advertisement
Table of Contents
