Adjusting Float For M200 And M205 Self-Propelled Windrowers; Removing And Restoring Float For M1240 Self-Propelled Windrowers - MacDon R85 Operator's Manual

4.1.2 Adjusting Float for M200 and M205 Self-Propelled Windrowers

DANGER
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove
the key from the ignition before leaving the operator's seat for any reason.
Set the float fine adjustment to MID-RANGE with the windrower float adjustment system in the cab (refer to your
windrower operator's manual).
Check the float by grasping the front corner of the header and lifting. The the weight should feel like 43–48 kg
(95–105 lb) and should be approximately the same at both ends.
If adjustment is required, follow these steps:
1. Raise the header fully.
2. Stop the engine and remove the key.
3. Turn drawbolt (A):
a. Clockwise to
header lighter).
b. Counterclockwise to DECREASE float (makes
header heavier).
4. Recheck the float.

4.1.3 Removing and Restoring Float for M1240 Self-Propelled Windrowers

Follow these steps to remove and restore the header float settings:
1. Press rotary scroll knob (A) on Harvest Performance
Tracker (HPT) to highlight QuickMenu options.
2. Rotate scroll knob (A) to highlight header float
adjust (B) and press scroll knob to select.
214014
OPERATING THE HEADER
INCREASE float (makes
Figure 4.1: Windrower Lift Linkage
Figure 4.2: Run Screen – HPT Display
84
Revision B