Drum Cartridge - Oil Change - Fayat Group DYNAPAC CA5000 Instruction Manual

Fig. Left drum side
1. Groove
2
Fig. Left drum side
1. Filler plug
2. Drain plug
3. Sight glass
2019-10-01

Drum cartridge - Oil change

1
Position the roller on a flat surface with the groove (1)
on the inside of the drum aligned with the top of the
drum frame.
Place a receptacle for about 5 liters (1.32 gal)
1
underneath the drain plug (2).
3
Clean and unscrew the filler plug (1) and the drain
plug (2).
Allow all the oil to run out. Fit the drain plug and fill
with new synthetic oil in accordance with the
instructions under "Drum cartridge - checking the oil
level".
Repeat the procedure on the opposite side.
4812158701_G.pdf
Maintenance - 2000h
Observe care when draining drum oil/hot drum oil. Observe care when draining drum oil/hot drum oil.
Wear protective gloves and goggles. Wear protective gloves and goggles.
Save the oil and hand in to an Save the oil and hand in to an
environment-friendly waste disposal station. environment-friendly waste disposal station.
Ensure that only Dynapac Drum Oil 1000 is used Ensure that only Dynapac Drum Oil 1000 is used
in the cartridges. in the cartridges.
145