Table of Contents
Advertisement
2
Fig. Left drum side
1. Filler plug
2. Drain plug
3. Sight glass
1
2
Fig. Wheels
1. Air valve
2. Wheel nut
2019-10-01
Place a receptacle for about 5 liters (1.32 gal)
1
underneath the drain plug (2).
3
Clean and unscrew the filler plug (1) and the drain
plug (2).
Allow all the oil to run out. Fit the drain plug and fill
with new synthetic oil in accordance with the
instructions under "Drum cartridge - checking the oil
level".
Repeat the procedure on the opposite side.
Tires - Air pressure - Wheel nuts - Tightening
Check the tire pressures using a pressure gauge.
If the tires are filled with fluid, the air valve (1) must be
in the "12 o'clock" position during pumping.
Recommended pressure: See Technical
Specifications.
Check the tire pressure.
Check the tightening torque of the wheel nuts (2) at
630 Nm (465 lbf.ft).
Check both wheels and all nuts. (This only applies to a
new machine or newly fitted wheels).
4812158701_G.pdf
Maintenance, first 50h
Observe care when draining drum oil/hot drum oil.
Observe care when draining drum oil/hot drum oil.
Wear protective gloves and goggles.
Wear protective gloves and goggles.
Save the oil and hand in to an
Save the oil and hand in to an
environment-friendly waste disposal station.
environment-friendly waste disposal station.
Ensure that only Dynapac Drum Oil 1000 is used
Ensure that only Dynapac Drum Oil 1000 is used
in the cartridges.
in the cartridges.
When changing the tires it is important that both
When changing the tires it is important that both
of them have the same rolling radius. This is
of them have the same rolling radius. This is
necessary to ensure proper functioning of the
necessary to ensure proper functioning of the
anti-slip in the rear axle.
anti-slip in the rear axle.
Check the safety manual that accompanies the
Check the safety manual that accompanies the
roller before filling the tires with air.
roller before filling the tires with air.
113
Advertisement
Table of Contents
