Table of Contents
Advertisement
Fig. Hydraulic reservoir
2. Filler cap/Bleeding filter
3. Sight glass
2019-10-01
Maintenance - 1000h
Performed after 1000 operating hours (each year)
Hydraulic filter - Replacement
Undo the filler cap/bleeder filter (2) on top of the
reservoir so that over-pressure inside the reservoir can
be eliminated.
Make sure that the bleeding filter (2) is not clogged, air
must have unobstructed passage through the cap in
2
both directions.
If passage in either direction is blocked, clean the filter
with a little diesel oil and blow through with
compressed air until the block is removed, or replace
3
the cap with a new one.
4812158701_G.pdf
Maintenance - 1000h
Park the roller on a level surface.
Park the roller on a level surface.
The engine must be switched off and the
The engine must be switched off and the
parking brake activated when checking or
parking brake activated when checking or
adjusting the roller, unless otherwise specified.
adjusting the roller, unless otherwise specified.
Ensure that there is good ventilation (air
Ensure that there is good ventilation (air
extraction) if the engine is run indoors. Risk of
extraction) if the engine is run indoors. Risk of
carbon monoxide poisoning.
carbon monoxide poisoning.
Wear protective goggles when working with
Wear protective goggles when working with
compressed air.
compressed air.
131
Advertisement
Table of Contents
