Table of Contents
Advertisement
1
Fig. Propulsion pump
1. By-pass valves
Fig. Control panel
2. Parking brake knob
86
Short distance towing with the engine running
Open the hood and make sure that the propulsion
pump is accessible.
On the pump there are two by-pass valves (1) (hex
screws), which should be turned three turns
anticlockwise to put the system in by-pass mode.
This function enables a machine to be moved.
Start the engine and allow it to idle.
Deactivate the brake with the parking brake knob(2).
Move the forward/reverse lever forwards or backwards
2
just outside the neutral position. If the control is in
neutral, the brakes are still activated.
The roller can now be towed and can also be steered
if the steering system is otherwise functioning.
To disengage the by-pass mode, turn back the
by-pass valves (1) three turns clockwise.
4812158701_G.pdf
Activate the parking brake, and temporarily stop
Activate the parking brake, and temporarily stop
the engine. Chock the wheels to prevent the roller
the engine. Chock the wheels to prevent the roller
from moving.
from moving.
The machine must not be moved at a speed
The machine must not be moved at a speed
higher than 3 km/h (2 mph), and no more than
higher than 3 km/h (2 mph), and no more than
300 meters (330 yards). Otherwise there is a risk
300 meters (330 yards). Otherwise there is a risk
of damaging the drives. Be sure to reset the
of damaging the drives. Be sure to reset the
towing valves (by turning them three turns
towing valves (by turning them three turns
clockwise) after towing.
clockwise) after towing.
Miscellaneous
2019-10-01
Advertisement
Table of Contents
