Drum Cartridge - Checking The Oil Level - Fayat Group DYNAPAC CA5000 Instruction Manual

1
Fig. Engine compartment
1. Hydraulic fluid filter (x 1).
Fig. Left drum side
1. Groove
132
Clean thoroughly around the oil filter.
Thoroughly clean the filter holder's sealing surfaces.
Apply a thin coat of fresh hydraulic fluid on the new
filter seal. Screw tight the filter by hand.
Start the engine and check that there is no leakage of
hydraulic fluid from the filter. Check level of fluid in the
sight glass (3) and top up as required.

Drum cartridge - Checking the oil level

1
Position the roller on a flat surface with the groove (1)
on the inside of the drum aligned with the top of the
drum frame.
4812158701_G.pdf
Maintenance - 1000h
Remove the oil filter (1) and hand in to an Remove the oil filter (1) and hand in to an
environment-friendly waste disposal station. This environment-friendly waste disposal station. This
is a single-use filter and cannot be cleaned. is a single-use filter and cannot be cleaned.
Make sure that the old sealing ring is not left on Make sure that the old sealing ring is not left on
the filter holder, Otherwise, this could cause the filter holder, Otherwise, this could cause
leakage between the new seal and the old one. leakage between the new seal and the old one.
First tighten the filter until its seal is in contact First tighten the filter until its seal is in contact
with the filter attachment. Then turn an additional with the filter attachment. Then turn an additional
half revolution. Do not tighten the filter too hard half revolution. Do not tighten the filter too hard
as this could damage the gasket. as this could damage the gasket.
Ensue that there is good ventilation (air extraction) Ensue that there is good ventilation (air extraction)
if the engine is run indoors. Risk of carbon if the engine is run indoors. Risk of carbon
monoxide poisoning. monoxide poisoning.
2019-10-01