Table of Contents
Advertisement
Fig. Left drum side
1. Groove
2
Fig. Left drum side
1. Filler plug
2. Drain plug
3. Sight glass
2019-04-30
Maintenance measures - 250 h
Every 250/750/1250/1750..... hours of operation (every
3 months)
Drum cartridge - Checking the oil level
1
Position the roller on a flat surface with the groove (1)
on the inside of the drum aligned with the top of the
drum frame.
The oil should now come up to the sight glass (3).
1
If necessary, release the filler plug (1) and fill to half
the sight glass (3).
Clean the magnetic filler plug (1) of any metallic
residue, before refitting the plug.
3
Now repeat the procedure on the opposite side of the
drum.
4812163801.pdf
Maintenance measures - 250 h
Park the roller on a level surface.
Park the roller on a level surface.
The engine must be switched off and the
The engine must be switched off and the
parking brake activated when checking or
parking brake activated when checking or
adjusting the roller, unless otherwise specified.
adjusting the roller, unless otherwise specified.
Ensure that there is good ventilation (air
Ensure that there is good ventilation (air
extraction) if the engine is run indoors. Risk of
extraction) if the engine is run indoors. Risk of
carbon monoxide poisoning.
carbon monoxide poisoning.
Ensure that only Dynapac Drum Oil 1000 is used
Ensure that only Dynapac Drum Oil 1000 is used
in the cartridges.
in the cartridges.
Do not overfill with oil - risk for overheating.
Do not overfill with oil - risk for overheating.
125
Advertisement
Table of Contents
