Table of Contents
Advertisement
Measurement Band
Auto / C Band / L Band / C+ L Band / Manual
When Manual is selected, the Measurement Start and End must be set (in nm or THz
according to the unit defined in Spectral Unit parameter).
Alarms parameters
In the Setup menu, press Alarms.
Figure 7
Alarms parameters
Alarms Status
None
Active
Auto Values
No
Yes
Bit rate info.
This table provides the PMD thresholds according to the transmission bit rate:
None / 2.5 Gb/s / 10 Gb/s / 40 Gb/s / 10 G Ethernet / 100 Gb/s..
Chapter 2 Polarization Mode Dispersion Measurement
No Pass/Fail thresholds selected.
Pass/Fail analysis will be made upon defined thresholds: auto values
or delay.
Threshold values entered manually.
Threshold values automatically calculated according to the bit rate
info selection.
User Manual
700MAN902 Rev. 000
Configuring the PMD test
13
Advertisement
Table of Contents
