Display of CD results
General display
Once the acquisition is completed, the result curve is automatically displayed. The Delay
curve is always displayed first.
Figure 40
Delay Curve
Fit Formula
Measured
points
Normalized
to km
The information provided with the delay curve may be different depending on to the
parameters settings. In the
•
Normalized to km : Yes
•
Show Measured Points: Yes
•
Show Fit Formula: Yes
NOTE
If the parameter Normalized to km is set to No, the result table will not dis-
play the Dispersion Coef (ps/nm.km) values.
Chapter 4 CD measurements using phase shift method
Figure
40, the following parameters have been configured:
User Manual
700MAN902 Rev. 000
Display of CD results
65