Table of Contents
Advertisement
Chapter 3 Attenuation profile
Configuring the AP test
NOTE
In case of OBS5xx handheld sources, the measurement will be performed
exclusively on SCL band.
Averaging acquisition
It enables to improve the dynamic range of the measurement by reducing the noise
level. It is recommended to use the Auto mode and configure a manual averaging if
needed only:
No
Low
Medium
High
Power Level
This parameter enables to get a power level indication at the start of an acquisition
No
Yes
NOTE
If Yes is selected, the acquisition stops if not enough power is received.
Analysis parameters
In the Setup menu, press Analysis.
36
No average of the acquisition sample to be performed.
Low averaging (4 samples).
Medium averaging (16 samples).
High averaging (32 samples).
the received power is not indicated before starting the measurement
acquisition.
the received power is indicated at the beginning of measurement.
User Manual
700MAN902 Rev. 000
Advertisement
Table of Contents
