Table of Contents
Advertisement
Chapter 3 Attenuation profile
Performing a AP measurement
Performing a AP measurement
When the reference measurement of the broadband source has been completed, use
the following procedure to make a measurement:
1
Disconnect the mating adapter and connect each fiber patchcord to the end of the
fiber under test.
2
Press the S
3
Select the appropriate AP test setup according to your application as earlier
defined in
4
Press the S
5
Repeat step 1 to 4 for every fiber to be tested.
NOTE
When the composite power of the input signal is higher than +20 dBm, a
warning is displayed and the signal is cut off.
OBS-5XX
44
button to access the configuration menu.
ETUP
"AP Activation and self calibration" on page
/S
button to perform the measurement.
TART
TOP
fiber patchcords
User Manual
Fiber under test
700MAN902 Rev. 000
34.
Advertisement
Table of Contents
