Table of Contents
Advertisement
•
The reference of a stored result can be updated using the reference stored in the
test set. Measurement will then be updated accordingly. To do so press the action
key: Update Trace With Ref.: apply the acquisition reference parameters to the
loaded curve.
Performing a CD Measurement
Once the reference measurement is correctly performed:
1
Disconnect the mating adapter and connect each fiber patchcord to the end of the
fiber under test
2
Select the appropriate CD test parameters according to your application (see
activation and self calibration" on page
3
Press the S
4
Repeat steps 1 to 4 for every fiber to be tested
Figure 39
Connections for the CD Measurement
OBS-5XX
Chapter 4 CD measurements using phase shift method
/S
button to see the results within a few seconds.
TART
TOP
fiber patchcords
User Manual
Performing a CD Measurement
52).
Fiber under test
700MAN902 Rev. 000
"CD
63
Advertisement
Table of Contents
