Table of Contents
Advertisement
Long term
Enables to repeat the measurement defined by the number of sweeps, over a given
period and to obtain statistical results:
None
Manual
Period
Wait Period
The Wait Period parameter allows to enter a time between 2 acquisition samples (only
active if Long Term is positioned on Period)
•
Increments of 5 seconds to 24 hours.
High Dynamic
Auto
No
Yes
Analysis parameters
In the Setup menu, press Analysis.
Figure 6
Analysis parameters
Chapter 2 Polarization Mode Dispersion Measurement
Samples are displayed one after the other;
Requires the user to press the
sample.
Defines time between 2 samples. To be configured with wait
period parameter.
The Dynamic range is automatically selected
High dynamic mode is not used for measurement
High dynamic mode is selected for measurement
User Manual
Stop Wait
700MAN902 Rev. 000
Configuring the PMD test
button to start the next
11
Advertisement
Table of Contents
