Command Interface Post Commands - CyberData 011403 Operation Manual

2.5 Command Interface
Some functions on the device can be activated using simple POST commands to the web interface.
The examples in
commands to the device should work.

2.5.1 Command Interface Post Commands

These commands require an authenticated session (a valid username and password to work).
Device Action
Reboot
Place call to extension (example: extension 600)
Terminate a call
Speak IP Address
Test Audio
Swap Boot partitions
a.Type and enter all of each http POST command on one line.
Operations Guide
Table 2-23 use the free unix utility, wget, but any program that can send http POST
Table 2-23. Command Interface Post Commands
HTTP Post Command
wget --user admin --password admin --auth-no-challenge --quiet -O
/dev/null --no-check-certificate "https://10.10.1.247/command" --
post-data "request=reboot"
wget --user admin --password admin --auth-no-challenge --quiet -O
/dev/null --no-check-certificate "https://10.10.1.247/command" --
post-data "request=call&extension=600"
wget --user admin --password admin --auth-no-challenge --quiet -O
/dev/null --no-check-certificate "https://10.10.1.247/command" --
post-data "request=terminate"
wget --user admin --password admin --auth-no-challenge --quiet -O
/dev/null --no-check-certificate "https://10.10.1.247/command" --
post-data "request=speak_ip_address"
wget --user admin --password admin --auth-no-challenge --quiet -O
/dev/null --no-check-certificate "https://10.10.1.247/command" --
post-data "request=test_audio"
wget --user admin --password admin --auth-no-challenge --no-
check-certificate --quiet -O /dev/null "https://10.10.1.81/command" --
post-data "request=swap_boot_partition"
931976A
Installing the InformaCast Enabled Paging Amplifier
InformaCast Enabled Paging Amplifier Setup
a
CyberData Corporation
92