Factory Default Settings - CyberData 011403 Operation Manual

2.3 Configure the InformaCast Enabled Paging Amplifier
Parameters
To configure the InformaCast Enabled Paging Amplifier online, use a standard web browser.
Configure each InformaCast Enabled Paging Amplifier and verify its operation before you mount it.
When you are ready to mount an InformaCast Enabled Paging Amplifier, refer to
"Mounting the Amplifier"

2.3.1 Factory Default Settings

All InformaCast Enabled Paging Amplifiers are initially configured with the following default IP
settings:
When configuring more than one InformaCast Enabled Paging Amplifier, attach the InformaCast
Enabled Paging Amplifiers to the network and configure one at a time to avoid IP address conflicts.
Operations Guide
for instructions.
Table 2-7. Factory Default Settings
Parameter
IP Addressing
a
IP Address
Web Access Username
Web Access Password
a
Subnet Mask
a
Default Gateway
a. Default if there is not a DHCP server present.
931976A
Installing the InformaCast Enabled Paging Amplifier
InformaCast Enabled Paging Amplifier Setup
Factory Default Setting
DHCP
192.168.1.23
admin
admin
255.255.255.0
192.168.1.1
Appendix A,
CyberData Corporation
24