Configure The Autoprovisioning Parameters - CyberData 011403 Operation Manual

2.3.14 Configure the Autoprovisioning Parameters

Autoprovisioning can be used to automatically configure your device. The autoprovisioning file is an
xml file with the device configuration. Values found in this file will override values stored in on-board
memory.
Note
1. Click the Autoprov menu button to open the Autoprovisioning page. See
CyberData InformaCast SIP
Operations Guide
By default, the device will try to set up its configuration with autoprovisioning.
Figure 2-42. Autoprovisioning Page
Paging Amp
931976A
Installing the InformaCast Enabled Paging Amplifier
InformaCast Enabled Paging Amplifier Setup
CyberData Corporation
76
Figure 2-42.