KYMCO Dink-R 150 Manual page 229

18
. INSTRUMENT/SWITCHES/LIGHTS
HEADLIGHT CONTROLLER
The Headlight is come on when the engine
starts.
INSPECTION
Turn the ignition switch to "ON"
Connect the multimeter (+) probe to the
Black/Green terminal and the multi-meter
(-)probe to the Green terminal.
The voltage is the battery voltage.
Starts the engine.
Connect the multimeter (+) probe to the
white/Blue terminal and the multi-meter (-)
probe to the Green terminal.
The voltage is the battery voltage.
TAILLIGHT/BRAKE LIGHT
Remove the seat and met-in box (2-4) .
Remove the center cover(2-5).
Remove the rear carrier(2-5).
Remove the rear center cover(2-5).
Remove the rear fender(2-5).
Remove the frame body cover(2-6).
Remove the
screws(red) and fasteners(blue)
attaching the taillight/brake lights.
The installation sequence is the reverse of
removal.
REAR TURN SIGNAL LIGHTS
Remove the nuts(yellow) attaching the rear
turn signal lights.
Disconnect the rear turn signal lights
connector.
Remove the rear turn signal lights.
The installation sequence is the reverse of
removal.
18-7
Dink-R 150
Headlight controller
OUT（TO Dimmer
Switch 12V）
INPUT（from
Ignition switch）
Taillight/brake light
Rear turn signal light
GND
RPM-ING(ECU)