Headlight Aim; Brake Fluid; Brake Pad Wear - KYMCO Dink-R 150 Manual

3
Dink-R 150
. INSPECTION/ADJUSTMENT
HEADLIGHT ADJUSTMENT
Headlight aim can be made by turning the screw
in or out as necessary.
Adjustment Screw

BRAKE FLUID

Brake fluid level:
With the scooter in an upright position, check
the front and rear fluid level. It should be above
the lower level mark. If the level is at or below
the lower level mark "L", check the brake pads
for wear.
Worn pads should be replaced. If the pads are
not worn, have your brake system inspected for
leaks.
The recommended brake fluid is DOT 4 brake
fluid from a sealed container, or an equivalent.

BRAKE PAD WEAR

Brake pad wear depends upon the severity of
usage, the type of riding, and road conditions.
(Generally, the pads will wear faster on wet and
Front brake
dirty roads.)
Check the cutout in each pad.
If either pad is worn to the cutout, replace both
pads as a set.
Rear brake
Check the cutout in each pad.
If either pad is worn to the cutout, replace both
pads as a set.
Rear brake
3-12