KYMCO Dink-R 150 Manual page 185

13
.
STEERING HANDLEBAR/FRONT WHEEL/
FRONT BRAKE/FRONT SHOCK ABSORBER/FRONT FORK
Place the brake master cylinder on the handlebar
and install the holder with the "up" mark facing up.
Also align the punch mark with the holder joint
seam.
First tighten the upper bolt and then tighten the
lower bolt.
Torque: 1.0～1.4kg-m
Install the brake fluid tube with the attaching bolt
and two sealing washers.
Install the handlebar covers.
Connect the front and rear stop switch wire
connectors.
Fill the brake reservoir with recommended brake
fluid to the upper limit and bleed air according to
the method stated in page 13-8.
BRAKE CALIPER
REMOVAL
Remove the brake caliper and brake pad springs.
Place a clean container under the brake caliper
and disconnect the brake fluid pipe from the
caliper.
＊
Do not spill brake fluid on any coated
surfaces.
DISASSEMBLY
Remove the brake caliper seat from the brake
caliper.
13-11
"Up" Mark
Fluid Tube Bolt
Brake Pads
Dink-R 150
Bolts
Washers
Bolts