KYMCO Dink-R 150 Manual page 197

14
. REAR WHEEL/REAR BRAKE/REAR
SHOCK ABSORBER
ASSEMBLY
Clean all removed parts.
Apply silicon grease to the piston and oil seal.
Lubricate the brake caliper cylinder inside wail
with brake fluid.
Install the brake caliper piston with grooved
side facing out.
Install the piston with its outer end protruding 3
〜5mm beyond the brake caliper.
Install the two spring plates onto the groove of the
caliper.
Make sure the spring plate next to the brake pad
dowel pin orientation.
Install two brake pads and brake pad dowe pin.l
14-5
Spring plate
Dowel Pin
Brake pads
Dink-R 150