KYMCO Dink-R 150 Manual page 224

18
. INSTRUMENT/SWITCHES/LIGHTS
FUEL PUMP
REMOVAL
Remove the seat and met-in.
Remove the center cover.
Remove the stay of floor plate.
Remove the fuel pump connector
Be sure to relieve the fuel pressure before
removing fuel pump or fuel hose.
Remove the six nuts and fuel unit
connectors then remove the fuel hose.
Remove the fuel pump
Check the fuel pump O-ring.
If was damage, replace a new one.
INSPECTION
Connect the fuel unit wire connectors and
turn the ignition switch "ON".
＊
Before performing the following test,
operate the turn signals to determine that
the battery circuit is normal.
Measure the resistance
Red/Black and Green wire of the fuel unit
connector.
Standard (at 20° C/68° F):
Float at full position
Float at empty position About 100 Ω
between the
About 2400 Ω
Fuel Hose
Connector
Dink-R 150
stay
E
F
18-2