Operation
Conductivity
82
ORP
The following settings for ORP measurements are reset to the default
settings with the Reset function:
Setting
Resolution mV
Man. temperature
Stability control
The sensor settings are reset under the Reset menu item in the menu
for calibration and measurement settings. To open the settings, display
the required measured parameter in the measured value display and
press the <MENU/ENTER> key.
The following settings for conductivity measurements are reset to the
default settings with the Reset function:
Setting
Cal. interval
Measured parameter
Cell constant (c)
Temperature compensation
Reference temperature
Temperature coefficient (TC) of
the linear temperature compen-
sation
TDS factor
Stability control
The sensor settings are reset under the Reset menu item in the menu
for calibration and measurement settings. To open the settings, display
the required measured parameter in the measured value display and
press the <MENU/ENTER> key.
Default settings
0.1
25 °C
On
Default settings
150 d
ӕ
Depending on the connected
measuring cell:
-1
0.475 cm
(calibrated)
-1
0.475 cm
(set up)
-1
0.100 cm
nLF
25 °C
2.000 %/K
1.00
On
ba75863e02
Multi 3410
12/2009