Performing A System Test; Performing An Inventory - Quantum ACL 4/52 Installation Manual

Performing a System
3
Test
Performing an
3
Inventory
• Auto clean (enable/disable)
• Retries (enable/disable)
• Exabyte emulation (enable/disable)
• Read barcode labels (yes/no)
• Auto inventory (yes/no)
• Auto load (enable/disable)
These procedures require operator- or service-level security clearance
at the library control panel. For a description of these procedures, refer
to the ACL 4/52 Operator's Guide.
The system test checks out the functionality of all library components.
To run the system test, you must have Service-level access at the
control panel.
The inventory command identifies tape cartridges by reading their bar
code labels and writes their location to nonvolatile RAM. To run the
inventory command, you must have either Operator- or Service-level
access at the control panel.
For more information about this command, refer to the ACL 4/52
Operator's Guide.
ACL 4/52 Facilities Planning and Installation Guide
Chapter 3 Installing the Library
Setting Up and Testing the Library
25