31/CARBURETOR
Carburetor - adjusting idle speed (50 SX Mini)
18.19
–
Screw in idle air adjusting screw
position.
Guideline
Idle air adjusting screw
Open
–
Run the engine until warm.
Guideline
Warm-up time
700522-01
Danger
Danger of poisoning Exhaust gases are poisonous and inhaling them may
result in unconsciousness and/or death.
–
When running the engine, always make sure there is sufficient ventila-
tion, and do not start or run the engine in an enclosed space without an
effective exhaust extraction system.
–
Adjust the idle speed with the adjusting screw
Guideline
Choke function deactivated – The choke lever is pushed down all the way.
Idle speed
–
Turn idle air adjusting screw
begins to fall.
–
Note the position and turn the idle air adjusting screw slowly counterclockwise until
the idle speed falls again.
–
Adjust to the point between these two positions with the highest idle speed.
Info
If the speed rise is too high, reduce the idle speed to a normal level and
repeat the preceding steps.
If the procedure described here does not lead to satisfactory results, the
cause may be a wrongly dimensioned idling jet.
If you can turn the idle air adjusting screw to the end without any change of
engine speed, you need to install a smaller idling jet.
After changing the idling jet, start from the beginning with the adjusting
steps.
Following extreme air temperature or altitude changes, adjust the idle speed
again.
all the way and turn it to the specified basic
1 turn
≥ 5 min
.
1,400... 1,500 rpm
slowly in a clockwise direction until the idle speed
108