30/DISASSEMBLING THE ENGINE
Clamping the engine into the engine work stand
15.1
Pulling off the spark plug connector
15.2
Draining the gear oil
15.3
Removing the cylinder head
15.4
–
Mount special tool
Engine work stand (61229001000) (
Fitting for work stand (45229001060) (
Holder of engine work stand (45229001070) (
–
Mount the engine on special tool
300729-10
–
Pull of spark plug connector
300460-10
–
Remove oil drain plug
–
Completely drain the gear oil.
300461-10
–
Remove spark plug
–
Alternately loosen screws
–
Take off the cylinder head.
300462-10
–
Remove the O-rings.
300463-10
on engine work stand
.
p. 146)
p. 142)
.
.
with the magnet and seal ring.
.
and remove them.
p. 142)
68