Assembling The Damper (50 Sx) - KTM 50 SX 2010 Repair Manual

04/SHOCK ABSORBER, SWINGARM

Assembling the damper (50 SX)

6.18
–
Mount rebound shim stack
300416-10
–
Mount supporting plate
300417-10
–
Mount and tighten the nut.
Guideline
Nut, piston rod
300418-10
–
Assemble the piston rod. (
–
Mount and tighten the screw of the filling port with a new sealing washer.
Guideline
Screw, filling port
–
Fill the damper cartridge.
Guideline
Fluid level below top edge
Shock absorber oil (SAE 2.5) (50180342S1) (
300441-10
–
Mount and oil piston ring
–
Grease the O-ring of the gasket support.
Lubricant (T158) (
–
Carefully mount the piston rod.
300442-10
–
Push in seal ring retainer
–
Mount lock ring
Info
First insert the closed part of the lock ring and then the two ends to pre-
vent the surface of the damper cartridge under the groove from becoming
scratched and the O-ring from being damaged during installation or opera-
tion.
300443-10
with the smaller disks facing up.

.

M10x1
p. 31)
M5
55 mm (2.17 in)
in the groove of the piston.

p. 140)
.

.

30 Nm
(22.1 lbf ft)
3 Nm (2.2 lbf ft)
p. 139)
32