Table of Contents
Advertisement
13/BRAKE SYSTEM
Changing the front brake linings
13.10
Warning
Skin irritation Brake fluid can cause skin irritation on contact.
–
Avoid contact with skin and eyes, and keep out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
If brake fluid gets into your eyes, rinse thoroughly with water and contact a doctor immediately.
Warning
Danger of accidents Reduced braking effect caused by old brake fluid.
–
Change the brake fluid of the front and rear brakes according to the service schedule.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
Never user DOT 5 brake fluid! This is based on silicone oil and is colored purple. Oil seals and brake lines are not designed for
DOT 5 brake fluid.
Avoid contact between brake fluid and painted parts. Brake fluid attacks paint!
Use only clean brake fluid from a sealed container!
–
Insert the brake linings.
Info
Ensure that the brake linings are correctly positioned in the holding spring.
700500-01
–
Mount screw
–
Fit the lock washer
–
Install the front wheel. (
700501-01
–
Remove the front brake linings. (
–
Move the brake fluid reservoir mounted on the handlebar to a horizontal position.
–
Remove screws
–
Remove cover
–
Press the brake piston back to its basic position and make sure that no brake fluid
overflows from the brake fluid reservoir.
–
Install the front brake linings. (
–
Correct the brake fluid level.
Guideline
301061-10
Brake fluid level under top level of con-
tainer
Brake fluid DOT 4 / DOT 5.1 (
–
Position the cover with the diaphragm. Mount and tighten the screws.
Info
Clean up overflowed or spilt brake fluid immediately with water.
.
.
p. 46)
p. 56)
.
with diaphragm
.
p. 56)
p. 138)
5 mm (0.2 in)
57
Advertisement
Table of Contents
