Generator Configuration; Generator Parameter Settings; Power Inputs - Deif ASC-4 Commissioning Manuallines

9. Generator configuration

9.1

Generator parameter settings

Before starting on this setup, please adjust the multi-inputs 102, 105, 108 to the needed input type, for instance 4-20 mA inputs. This
applies only for units with option G5/M4 and if the transducer inputs are being used.
The chapter describes the configuration and setup of the generator and mains values. It is easily done in the utility software.
You need to go through these steps when the system is a stand-alone system. If the system is an integrated power management
system, the ASC retrieves the data from the power management communication lines.
Nominal power
Note that the generator power is adjusted in kW rather than kVA. The kW value can be found by multiplying the kVA value of the
generator with the generator power factor.
In this example, there is one generator, called DG1 and its size is 100 kW.
9.2

Power inputs

The "power inputs" define where the ASC receives the data from for the generator power.
COMMISSIONING GUIDELINES 4189341077D EN Page 24 of 58