JAI GO-2400M-PGE User Manual page 32

GO-2400MC-PGE | GO-2401MC-PGE | User Manual (Ver. 3.0)
When Controlling the Exposure Time using the Pulse Width of the Trigger Input Signal
Configure the settings as follows.
Item
Trigger Selector
- Trigger Mode
- Trigger Source
- Trigger Activation
Exposure Mode
1. Set Exposure Mode to Trigger Width. When you select Trigger Width, Trigger Mode will
automatically be set to On.
2. Set Trigger Selector to Frame Start. (Frame Start is the default setting.)
3. If necessary, change the Trigger Source and Trigger Activation settings.
Other Controls
In addition to exposure time, the following can also be controlled by external triggers. Select these
control operations in Trigger Selector.
Trigger Selector
Settings
Acquisition Start
Acquisition End
Acquisition Transfer
Start
Frame Start
On
Any
Level High, Level Low
Trigger Width
Start image acquisition.
Stop image acquisition.
Output acquired images at a specified timing. (Up to 7 frames for 8-bit, and up to 3
frames for 10-/12-bit.)
Setting Value / Selectable Range
Description
- 32 -
Preparation