Fayat Group DYNAPAC CA1300 D Instruction Manual page 95

Load carrier Load carrier
- - Load the roller in the centre of the platform from the sides (± 5 cm) and facing forwards. Load the roller in the centre of the platform from the sides (± 5 cm) and facing forwards.
- - The parking brake is applied and in good working condition. The parking brake is applied and in good working condition.
- - The drums are placed on rubber friction pads (4) to achieve the static friction 0.6 between the The drums are placed on rubber friction pads (4) to achieve the static friction 0.6 between the
surfaces. surfaces.
- - The contact surfaces must be clean, wet or dry, and free from frost, ice and snow. If there is a The contact surfaces must be clean, wet or dry, and free from frost, ice and snow. If there is a
risk of frost, ice and/or snow the platform has to be salted. risk of frost, ice and/or snow the platform has to be salted.
- - The lashing mounts on the load carrier have MSL/LC/SWL at least 2 tonnes. The lashing mounts on the load carrier have MSL/LC/SWL at least 2 tonnes.
Lashings Lashings
- - The maximum securing load (MSL/LC/SWL) of the lashings (strap or chain) is at least 1.6 The maximum securing load (MSL/LC/SWL) of the lashings (strap or chain) is at least 1.6
tonnes (1,600 daN) and the lashings are well pre-tensioned during the entire transport. tonnes (1,600 daN) and the lashings are well pre-tensioned during the entire transport.
- - Each of lashings 1-3 is either one double or two single lashings. The double lashing is the Each of lashings 1-3 is either one double or two single lashings. The double lashing is the
same lashing in a sling through a lashing eye or round a machinery part down in two different same lashing in a sling through a lashing eye or round a machinery part down in two different
lashing points on the platform. lashing points on the platform.
- - Lashings in the same direction are placed in different lashing mounts on the trailer. Lashings Lashings in the same direction are placed in different lashing mounts on the trailer. Lashings
that are pulled in opposite directions may be placed in the same lashing mount, however. that are pulled in opposite directions may be placed in the same lashing mount, however.
- - The lashings are as short as possible. The lashings are as short as possible.
- - The lashing hooks must not lose grip if the lashings become slack. The lashing hooks must not lose grip if the lashings become slack.
- - The lashings are protected against sharp edges and corners. The lashings are protected against sharp edges and corners.
- - The lashings are located symmetrically in pairs on the right and left sides. The lashings are located symmetrically in pairs on the right and left sides.
2023-05-26 4812165001.pdf
Miscellaneous
77