Table of Contents
Advertisement
Fig. Forward/reverse lever
3
1
Fig. Forward/reverse lever, Cab
1. Forward/Reverse lever
2. Plate
3. Screw
258
Forward/Reverse controls and joints
- Check and lubrication
Accessing the machine fitted with ROPS
The easiest way to access the forward/reverse lever
pivot points is via the operator's manual pocket on
the right-hand side of the driver's seat.
Access on machine with cab
The forward/reverse lever pivot points are accessed
by removing four screws (3) on the plate (2) under
the forward/reverse lever (1).
Check friction of the forward/reverse lever.
The friction screws must be sufficiently tightened to
retain the forward/reverse lever in the position set
2
during operation. The "0" position of the controls is
determined by a screw that engages in the groove on
the shaft between the controls.
If the lever begins to become stiff after prolonged
used, lubricate the lever at the control cable with
a few drops of oil at each point.
4812165001.pdf
Maintenance, 9000h
2023-05-26
Advertisement
Table of Contents
