Fayat Group DYNAPAC CA1300 D Instruction Manual page 269

Vibratory roller
Table of Contents

Advertisement

1
Fig. Hydraulic reservoir, bottom
1. Drain plug
1
Fig. Hydraulic reservoir
1. Filler cap/Breather filter
2023-05-26
Hydraulic reservoir - Draining
Condensate in the hydraulic reservoir is drained via
the drain plug (1).
Drain the roller after it has been stationary for a long
time, e.g. after standing overnight. Drain as follows:
Place a container under the drain hole.
Remove the plug (1).
Drain off any condensate.
Refit the plug.
Hydraulic filter - Replacement
Release the filler cap/breather filter (1) so that any
overpressure inside the reservoir is eliminated.
Check that the breather filter (1) is not clogged.
Air should be able to pass freely through the cap
in both directions.
If passage in either direction is blocked,
clean the filter with a little diesel oil and blow through
with compressed air until the block is removed,
or replace the cap with a new one.
When working with compressed air,
When working with compressed air,
use the following protective equipment:
use the following protective equipment:
Safety glasses
Safety glasses
4812165001.pdf
Maintenance, 9000h
251

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dynapac ca1300 pd

Table of Contents