Fayat Group DYNAPAC CA1300 D Instruction Manual page 78

Vibratory roller
Table of Contents

Advertisement

5
Fig. Control panel
5. Indicator lamp, parked regeneration
8. Indicator lamp, less serious error
9. HEST (High Exhaust Temp) lamp
11. Switch for parked regen
(regeneration) of DPF filter
60
If the machine runs a lot on partial load, start-stop and
at low engine temperatures, etc., a parked regen
(regeneration) may need to be performed.
This is indicated by the lamp for Parked Regen
Requested (5) is required, comes on, the indicator
lamp (8) flashes and there is a signal from the buzzer.
The operator should park the machine at a suitable
11
9
place and allow the engine to run.
The parking brake must be activated, the machine
8
must be stationary and the control lever must be in
neutral.
The engine should be warm.
When the conditions are met, the switch (11) for
Parked regen flashes.
To start the parked regeneration, press the switch
Parked Regen Requested (11) and hold for at least
three seconds.
This is done by moving up the yellow lock and
pressing the switch. The switch will spring back
afterwards.
The speed of the engine increases and the lamp in the
switch (11) stops flashing but stays on. HEST (High
Exhaust Temp) lamp (9) lights up and stays on. The
indicator lamps for Parked Regen (5) and Engine
Diagnostics (Serious fault) (7) go out. The buzzer
sounds.
The regen of the DPF filter takes approx. 30 minutes.
The engine then returns to low speed. The HEST lamp
(9) and the Parked Regen switch (11) go out.
When the regen is finished and if the machine is being
used again, disable the parking brake.
The machine can now be used.
If it is not possible to do a parked regen, because the
place is not suitable or because the working conditions
will not permit it, do as follows:
- Drive the roller as soon as possible to a suitable
place.
- Park the roller, enable the parking brake and carry
out a parked regen.
HEST (High Exhaust Temp) the lamp (9) also comes
on when the engine makes a powerful Reset regen
every 100 hours, during operation. Continue operating
and working as usual.
4812165001.pdf
Operation
2023-05-26

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dynapac ca1300 pd

Table of Contents