Installing A Switch Using The Rkmt-J09 Rack Mount Kit; What To Prepare; Installing A Switch Using The Rack Mount Kit - Allied Telesis GS910/XST Series Installation And User Manual

Installing a Switch Using the RKMT-J09 Rack Mount Kit

What to Prepare

Installing a
Switch Using the
Rack Mount Kit
This section shows you steps to install a switch in an equipment rack using
the RKMT-J09 kit.
Before installing a switch to an equipment rack, make sure that the
following items are ready.
An RKMT-J09 rack mount kit

19-inch equipment rack

Four screws for the equipment rack

Phillips-head screw driver

To install a switch in a rack using the RKMT-J09 rack mount kit, perform
the following procedure:
1. Review "Reviewing Safety Precautions" on page 32.
2. Place all the items from the packaging on a work table.
3. Attach the handle to bracket with M3x6mm screws using a Phillip-head
screw driver as shown in Figure 33.
Figure 33. Attaching Handles to Brackets
4. Attach the bracket units to the switch with M3x6mm screws using a
Phillip-head screw driver as shown in Figure 34 on page 66.
Chapter 5: Rack Installation Using the RKMT-J09 Kit
65